Technical information on how to apply the paint
Thickness 1.0 mm 2.0 mm 3.0 mm Surface type light type, matte type, only slip type Years of use 1.0 mm: 5 years or more; 2.0 mm: 8 years or more; 3.0 mm: 10 years or more Floor features seamless dust, wear non-slip, acid and alkali, mildew waterproof, impact resistance, anti-chemical, moisture-proof slip Scope of application ① electronics, electrical appliances, hardware, machinery factory; ② chemical, pharmaceutical, laboratory; ③ food, textile, supermarket, parking lot Construction technology ① waterproof treatment: the first floor of the ground have to do a good job waterproofing; ② plain to deal with: according to the situation to do a good job repair, grinding, dust; ③ epoxy primer: the use of osmotic and strong adhesion of epoxy primer roll one to two, the surface is uniform, not white, to increase the strength and adhesion; ④ epoxy coating: the epoxy resin by adding the right amount of quartz sand, with a trowel to its uniform coating number; ⑤ epoxy batch: according to the actual needs of the construction of several channels, to achieve the formation of no holes, no batch of printing and polishing India shall prevail; ⑥ epoxy topcoat: solvent-based epoxy finish or slip-free finish paint roller two, after the completion of the overall surface bright and clean, uniform color, can increase a covered gold oil to extend the service life; ⑦ construction is completed: 24 hours before the man, 72 hours before the weight (25 ℃ prevail, low temperature opening time to be appropriate to extend, during the maintenance of the floor can not be water) The following are the same as the " Technical indicators The following are the same as the " Project indicators Drying time (H) ≤4 Drying time (H) ≤24 Applicable period (H) pass Impact resistance (1KG / 100 cm) coating without cracks, no peeling Adhesion (level spacing 1mm, the level) ≤ 1 Pencil hardness (abrasion) ≥H Wear resistance (750 g / 500 R) / G ≤ 0.03 Water resistance (7d) does not blister, do not fall off, allowing a slight discoloration, after 2H recovery Oil resistance (120 # gasoline, 7d) does not blister, do not fall off, allowing a slight discoloration Alkali resistance (20% NaOH, 72 hours) does not blister, does not fall off, allowing slight discoloration Acid resistance (10% H2SO4, 48h) does not blister, do not fall off, allowing slight discoloration Salt water resistance (3% NaCl, 7d) does not blister, do not fall off, allowing slight discoloration Adhesive strength / MPa ≥3.0 Compressive strength / MPa ≥ 80
|